The RCI-SE board includes 2 ADC IC’s:
- IC2 for Azimuth
- IC4 for Elevation
When a Voltage between 0V and 5V is applied on pin #2 on those IC’s,? around 17?secs later it’s converted into a digital value. The ARSWIN reads the digital value, and calculate the antenna position. This process is done based on some parameters that the user must provide:
- Left or CCW Limit
- Right or CW limit
- Total rotation anglee.
Aditionally the RCI-SE has 4 POT’s (2 peer input), that will be used for adjust the voltage limits at each input pin (pin #2). Those POT’s are:
- POT1: Amplifier or Gain Pot. (Azimuth)
- POT2: Amplifier or Gain Pot. (Elevation)
- POT3: Zero Offset (Azimuth)
- POT4: Zero Offset (Elevation)
POT1 and POT2 adapt the GAIN of each input, and will be ajusted when the rotator is at the CW or UP limits.
POT3 and POT4 adapt the ADC value when the rotator is at the CCW or DWN limits.
How must be done?
Check that POT3 and POT4 are at their CCW limits.
You must turn the rotor manually to the CW limit. This point should be 360?, or 180?. Some rotors as Yaesu, Kenpro or ProsSisTel allow a rotatation greater than 360?, however this overlapping is not useful for the ARS. So, remember to use this CW limit as 360?.
When this CW point is displayed at the rotor displayer (Control Unit), check the?“Current A/D Value”. Adjust POT1 (Azimuth) or POT2 (Elevation) untill the Current A/D Value is as close as possible to the Max ADC Limit.
This limit will be 1023 for 10 bits ADC or 255 for 8 bits ADC. And PRESS the?RIGHT Button?when it’s done.
This limit will provide around 5V at point X2 (Azimuth) or X3 (Elevation)
Later, turn the rotor to the CCW or Left Limit. It will be 0? or 180?. The actual A/D Value will be a value close to Zero.
If this value is not near to 0, ajust POT3 (or POT4 for elevation) till you read that the A/D Value is 0 or some value close to 0.
And Press?LEFT Button.
Now the ARSWIN has the 2 limits and will calculate the antenna position.
On above screens, the 2 limits selected are:?1021?and?9
Remember that you must indicate the total rotation limit that use to be 360? or 450? in most cases. You can also limit the rotation to a lower value as 180? or 90? in those cases where the rotation is limited by some oject.
Also you must indicate the left/CCW Limit of your motor. This parameter will indicate the position of the motor when it’s located at the left/CCW limit.
Some examples are:
- Yaesu, Kenpro –> 0
- HAMIV, T2X —–> 180
Offset must be set to Zero.